If you want to learn how to produce your own small electronics gadget then this Hackster post will give you some tips
In this project we are going to implement an IIR filter in an FPGA from scratch using bilinear transform and the prewarping technique.
LoRaWAN IoT system with the Arduino MKR WAN 1300, that help to monitor the air quality and water of an ecological area
AXI-Lite registers bank. Can be monitored/changed via TCL commands. Also monitored through a seven-segment display + onboard switches.
Control df mini player with esp8266
Here is a project that involves the electric side of your bike or car! we are building a 12V Bulb flashing circuit fully documented.
A robot that avoid the edge near him.
In this project we are going to connect and configure a PCIe WWAN modem to a Zynq MPSOC using Petalinux and the Genesys ZU 5EV board.
3D printed and run by a single stepper motor, this unique clock's hands float in a hollow frame.
How to create a Robotic Arm under the control of the new Kria Robotic Starter Kit
A project by a team of students from the Hebei University of Technology
The goal is to offload basic I/O processing to a FPGA and read/write the results via SPI from Raspberry PI Zero
Minimalistic Emergency ventilator with fine control over BPM, tidal volume and flow rate, with a digital interface.
How to build a wind turbine MPPT regulator within direct injection or battery configuration, 24V or 48V, 30A max. Update : V2 with a PCB.
Learn how to lift-off a drone with your mind and a hacked controller using a MindWave sensor, Arduino MKR1000 and Processing.
A smart city is an urban area that uses different types of electronic data collection sensors to supply information used to manage assets.
A digital finger sensor to protect against theft.
Minimalist cars race with a strip of smart LEDs and two switches.This project has evolved and now has its own website: www.openledrace.com
An animated cube made with 512 RGB LEDs driven by an ATmega328.
Leveraging HLS functions to create a image processing solution which implements edge detection (Sobel) in programmable logic.
Nice looking weather forecast for Raspberry Pi Zero and Ili9341 based 2.8 inch TFT.
Design of an indicative featured and speed controlled obstacle avoiding robot.
An automated, smart, self-contained growing system that cultivates plants from seed to maturity!
This project allows anyone to turn a Raspberry Pi into a universal remote using LIRC (LINUX Infrared Remote Control).