Let's Dance, put on your red shoes and dance the blues
Motor driver circuit with some power saving features.
This is a very simple way to control a 3-phase AC installation in a delta configuration.
Use this project to get started on your first Pynq design using the Pmod Hygro to monitor the temperature and humidity of your environment!
This circuit divides the voltage to three ranges: 12V DC, 9V DC and 5V DC.
Connect your FPGA project to a wireless network and get information about your system while on the network.
Spectrum Analyzer using Zybo Z7 board, PMOD AD2 and Processing v3.x for displaying the spectral lines.
It came with only an on/off switch. Adding an UNO to this LED chalkboard really gets your attention - it is quite a flashy pig.
A generic setup for museum exhibit automation. DFRobot 4 relay shield 2.1 and screw shields, Hitachi 16*2 Display shield on UNO or Mega.
Use to record somebody's blow strength. Since without calibration it is relative value.
A virtual reality system using a similar device to Google Cardboard, a compatible phone and a lot of cables.
Builds on the project Mini But Mightyu, the MiniZed and Vitis for Motor Control using the built in accelerometer to control the speed.
Raspberry Pi can be a good environmental monitor and can forbid you to drive if you're drunk.
Luciferin is a generic term for the light-emitting compound found in organisms that generate bioluminescence like Fireflies and Glow Worms.