Measuring resistance of short conducting wire in milliohms is not possible with multimeters but they can measure millivolts accurately.
Mechanical split flap displays controlled with the Pocket Beagle.
Creating a portable mesh network to send GPS coordinates from a handheld device to base camp using XBEE S3B units.
Simple DIY #Halloween decoration with #Arduino LCD #display and #WS2812B RGB lighting capable of #sound effects and #sensors
Monitor your daily water usage, donate water for remote areas, crop plantation using IoT.
This is a E-ink dashboard that provides real-time information pulled from API using a Raspberry Pi Zero.
Let's Dance, put on your red shoes and dance the blues
Luciferin is a generic term for the light-emitting compound found in organisms that generate bioluminescence like Fireflies and Glow Worms.
Raspberry Pi can be a good environmental monitor and can forbid you to drive if you're drunk.
Use this project to get started on your first Pynq design using the Pmod Hygro to monitor the temperature and humidity of your environment!
Builds on the project Mini But Mightyu, the MiniZed and Vitis for Motor Control using the built in accelerometer to control the speed.
Motor driver circuit with some power saving features.
This is a very simple way to control a 3-phase AC installation in a delta configuration.
This circuit divides the voltage to three ranges: 12V DC, 9V DC and 5V DC.
A virtual reality system using a similar device to Google Cardboard, a compatible phone and a lot of cables.
Connect your FPGA project to a wireless network and get information about your system while on the network.
Spectrum Analyzer using Zybo Z7 board, PMOD AD2 and Processing v3.x for displaying the spectral lines.
A generic setup for museum exhibit automation. DFRobot 4 relay shield 2.1 and screw shields, Hitachi 16*2 Display shield on UNO or Mega.
It came with only an on/off switch. Adding an UNO to this LED chalkboard really gets your attention - it is quite a flashy pig.