This is a E-ink dashboard that provides real-time information pulled from API using a Raspberry Pi Zero.
This is a very simple way to control a 3-phase AC installation in a delta configuration.
Motor driver circuit with some power saving features.
Connect your FPGA project to a wireless network and get information about your system while on the network.
Spectrum Analyzer using Zybo Z7 board, PMOD AD2 and Processing v3.x for displaying the spectral lines.
It came with only an on/off switch. Adding an UNO to this LED chalkboard really gets your attention - it is quite a flashy pig.
A generic setup for museum exhibit automation. DFRobot 4 relay shield 2.1 and screw shields, Hitachi 16*2 Display shield on UNO or Mega.
A virtual reality system using a similar device to Google Cardboard, a compatible phone and a lot of cables.
Monitor your daily water usage, donate water for remote areas, crop plantation using IoT.
Raspberry Pi can be a good environmental monitor and can forbid you to drive if you're drunk.
Use this project to get started on your first Pynq design using the Pmod Hygro to monitor the temperature and humidity of your environment!
Luciferin is a generic term for the light-emitting compound found in organisms that generate bioluminescence like Fireflies and Glow Worms.
Builds on the project Mini But Mightyu, the MiniZed and Vitis for Motor Control using the built in accelerometer to control the speed.
This circuit divides the voltage to three ranges: 12V DC, 9V DC and 5V DC.
Let's Dance, put on your red shoes and dance the blues