Basics on how to set up Zigbee using XCTU.
Build your own line following robot (line follower) step by step easily by following this tutorial
How to connect A6 GSM GPRS module with Arduino and also work with “AT” commands.
An alarm clock showing the Jewish (Hebrew) date, the Gregorian date, current time, time of nightfall, sunrise, etc
This is a cool IoT project for beginners using NodeMCU and Blynk app. Through this project, you can control 4 devices in your home.
This is a very simple way to control a 3-phase AC installation in a delta configuration.
Measuring the liquid flow by given volume or manually control it via mobile phone over MQTT protocol.
Monitor your daily water usage, donate water for remote areas, crop plantation using IoT.
This library allows an Arduino to easily display numbers and characters on a 4 digit 7-segment display without a separate 7-segment display.
This circuit divides the voltage to three ranges: 12V DC, 9V DC and 5V DC.
A digital thermometer built from scratch using Attiny85 and ds18b20 temperature sensor, which can run on a CR2032 over 130 days!
This thermostat can be used with any kind of water boiler and any kind of pump.
This is a low cost robot that will help students in better learning and understanding.
Current Source DAC AD5420 and Arduino UNO
How to build a remote controlled car toys using Arduino and Bluetooth Modul HC-05
LED indicators to show Dark or Light Level
To prevent the accident in advance and if accident occurs then there will be a prevention system to notify emergency services before time.
This project will go trough the process of acquiring an input signal through the Zmod ADC and re-creating the signal through the Zmod DAC.
It came with only an on/off switch. Adding an UNO to this LED chalkboard really gets your attention - it is quite a flashy pig.
Multipurpose dispenser made from components of water purifier, scrap & hardware to use either soap+water or sanitiser dispensing
Guide to use esp8266 flash memory and Little File system using using Arduino IDE. This guide covers how to read, write and delete data.
A simple tutorial to set up ICStation's DC to DC automatic boost buck converter (5 - 32V to 1.25 - 20V 5A) for electronic use.
This project uses an LCD screen and DHT22 to display temperature and humidity data, simultaneously collected from two different locations.
A general purpose wireless I/O board using a Particle Photon. Control a small motor, solenoid, servo, external loads, buzzer and sensors.