The Zybo is a feature-rich, ready-to-use, entry-level embedded software and digital circuit development platform built around the smallest member of the Xilinx Zynq-7000 family, the Z-7010. The Z-7010 is based on the Xilinx All Programmable System-on-Chip (AP SoC) architecture, which tightly integrates a dual-core ARM Cortex-A9 processor with Xilinx 7-series FPGA logic. When coupled with the rich set of multimedia and connectivity peripherals available on the Zybo, the Zynq Z-7010 can host a whole system design. The on-board memories, video and audio I/O, dual-role USB, Ethernet, and microSD slot will have your design up-and-ready with no additional hardware needed. Additionally, six Pmod connectors are available to put any design on an easy growth path. 


  • Xilinx Zynq-7000 (XC7Z010-1CLG400C)
  • 28,000 logic cells 
  • 240 KB Block RAM 
  • 80 DSP slices 
  • On-chip dual channel, 12-bit, 1 MSPS analog-to-digital converter (XADC) 
  • 650 MHz dual-core Cortex™-A9 processor 
  • On-board JTAG programming and UART to USB converter  
  • DDR3 memory controller with 8 DMA channels 
  • 512 MB x32 DDR3 w/ 1050Mbps bandwidth 
  • 128 Mb Serial Flash w/ QSPI interface  
  • microSD slot (supports Linux file system) 
  • High-bandwith peripheral controllers: 1G Ethernet, USB 2.0, SDIO 
  • Low-bandwidth peripheral controller: SPI, UART, I2C 
  • Dual-role (Source/Sink) HDMI port 
  • 16-bits per pixel VGA output port
  • Trimode (1Gbit/100Mbit/10Mbit) Ethernet PHY 
  • OTG USB 2.0 PHY (supports host and device)
  • External EEPROM (programmed with 48-bit globally unique EUI-48/64™ compatible identifier) 
  • Audio codec with headphone out, microphone and line in jacks 
  • GPIO: 6 pushbuttons, 4 slide switches, 5 LEDs  
  • Six Pmod ports (1 processor-dedicated, 1 dual analog/digital)  
Add projectSign up / Login