Lucian SABO
Published © CC BY-NC

Dulciurilla: Fitbit - Connected Candy Dispenser

This special candy dispenser will give you candies based on how you complete different fitness challenges.

AdvancedFull instructions provided3 days864
Dulciurilla: Fitbit - Connected Candy Dispenser

Things used in this project

Hardware components

NodeMCU ESP8266 Breakout Board
NodeMCU ESP8266 Breakout Board
×1
SparkFun Servo - Generic High Torque Continuous Rotation
×1
Female/Female Jumper Wires
Female/Female Jumper Wires
×1
Buzzer
Buzzer
×1
High Brightness LED, White
High Brightness LED, White
×2
Steel wire / hanger wire
×1
Plywood
×1
Padlock
×1
SparkFun Snappable Protoboard
SparkFun Snappable Protoboard
×1
General Purpose Transistor NPN
General Purpose Transistor NPN
I used 2N3904, but any NPN transistor can be used even BC547. This depends on the number of LEDs you use for illumination. A typical white LED will draw max 30 mA and I used two LEDs.
×1
Through Hole Resistor, 1.8 ohm
Through Hole Resistor, 1.8 ohm
×2
Through Hole Resistor, 4.7 kohm
Through Hole Resistor, 4.7 kohm
×1
2x6 Pin Header (5-pack)
Digilent 2x6 Pin Header (5-pack)
×1
Plexiglass
×1

Software apps and online services

Arduino IDE
Arduino IDE

Hand tools and fabrication machines

Jigsaw, pendular
Drill / Driver, Cordless
Drill / Driver, Cordless
Hot glue gun (generic)
Hot glue gun (generic)
Soldering iron (generic)
Soldering iron (generic)

Story

Read more

Schematics

LED Connection Board Fritizing Schematics

Fritizing schematics & PCB

Code

Dulciurilla Github repository

Credits

Lucian SABO

Lucian SABO

3 projects • 2 followers

Comments

Add projectSign up / Login